DTD Torque Arm View

[KTMLew]

https://www.youtube.com/watch?v=ZcbT3WGvD78

[KTMLew]

I guess it's poor form to reply to your own post, but since all 350+ of you that looked haven't, I expected even more movement. Always surprised more driveshafts aren't flying thru the air. The quality of the parts is insane now. Fairly rarely see failures.

[Jking24]

Might get more interest if you posted it in the tech section. Also if you had Somthing to comment about in the first place. You just posted a random video with no explanation or question

[MasterSbilt_Racer]

I guess it's poor form to reply to your own post, but since all 350+ of you that looked haven't, I expected even more movement. Always surprised more driveshafts aren't flying thru the air. The quality of the parts is insane now. Fairly rarely see failures.

That's actually pretty tame. Not a lot of pinion angle change. An old Rayburn with a pullbar would scare you.

[KTMLew]

Might get more interest if you posted it in the tech section. Also if you had Something to comment about in the first place. You just posted a random video with no explanation or question

From what I've seen this section of this board is the only one active. Video seemed pretty self-explanatory, had nearly 350 views, but I'll just not bother you again.

[KTMLew]

That's actually pretty tame. Not a lot of pinion angle change. An old Rayburn with a pullbar would scare you.

Which was also my take. Not nearly as much flopping around as I expected.