j bar help

[0007]

does the j bar need to run strait mine is not sitting in the car square and wondering if it could be binding

[washeduptoo]

If your talking about the frame end being ahead of the pinion end, yes, usually frame end is forward of pinion end.

[0007]

my pinion end is ahead of the frame end

[washeduptoo]

You might want to check the 72 inches from motor plate to center line of axle tube. I think that is the correct measurement. Good luck.

[1Blacksheep]

4 bar left and its ahead at the pinion can develop a bind and interference with other components.

[0007]

solid 3 link sportmod rearend is back far enough but it has spacers on each end where it bolts to pinion bracket and chassis bracket

[1Blacksheep]

If it was mine I would run it as close to parallel with the axle as possible on 3 link.

[0007]

ok thank you