straight bar

[chasefrehley]

Where on the pinion do I mount my straight bar?

[washeduptoo]

QC or 9in? On a QC we ran it 1.5-2 inch above center of pinion, on 9in center of pinion. Good luck

[bob75]

if it has 4 holes on the pinion, run 2nd from the top

[chasefrehley]

I have a quick change. Thank you for the help

[bob75]

thats what i run on my quick change (pierce car)

[chasefrehley]

i have a coyote.

[bob75]

it will work, start it were i told ya.

[chasefrehley]

what is the length of your bar cent to cent?

[bob75]

15inches thats a base line but check it to your side by side .mine is 14 5/8

[chasefrehley]

My bar is 17 3/4 cent to cent. That puts my drive shaft center to trany

[Anonymous24]

straight bar

All of those answers are wrong. Set car to ride height with the straight bar removed. Maintain pull/lift bar length and pinion angle to proper settings. Make sure RF and RR hub plates are in line with each other. Use the hole on the pinion plate that is on the axle centerline andmeasure its heighthfromnthe ground. Set the panhard bar chassis mount at that height so the bar will be level. Measure distance from chassis mount to axle mount. Your bar should be that length center to center. Install bar. That's not being technical because to be realistic it all depends on your front suspension in dynamic