anyone have any suggestions what would cause both radiator hoses to swell up big after you run. looked like they were about to blow. car got about 220 and never puked any water out.
motor help
Collapse
X
-
Yea,head gasket or cracked head causing pressure on the cooling system.Running hot,junk hoses,high pressure cap.Take the cap off,fire it up cold and see if it pushes water out or any air bubbles in the water.If not,keep it running to let it warm up some to see if it pushes water.
-
-
If its not getting hot, really hot, and its not putting water out i wouldnt think it was a head gasket.
my thoughts are that its just warm after it runs, heat builds pressure in the cooling system which swells the hoses some...to an extent.
Comment
-
Ive had piston to head to close and the piston would tap the head just enough to lift it and allow compression in the water system. I could race a night or tow with no issues then walla issues again... my water temp would spike when this happened though but thought I would throw it out there because you cant always see bubbles and you may still have a issue.
Comment
-
thanks. the hoses are old i should have replaced them last week when putting the new engine in. motor ran fine we won the heat and feature. took hood off after heat race and the top hose looked swelled up. ran 15 lap feature and temp was about 220 to 230 by the time we got to where we take pics. didnt push water out. checked water in it next morning and could touch it with my finger still. someone said something about bubbles what does that mean? also was checking it over and it has no thermostat but it had a little metal plate in the intake where your hose goes like a divider where your thermostat goes
Comment
-
Originally posted by runyou-2 View PostDDDDDaaayyyyyuuuummmmm jeff...you've done it all. what you call that? head lift?hahahhaha
yes in 20 years of racing I have had almost every problem twice... including the head lift issue....
worse to diagnose was hose in fuel cell loose at the fitting.... weeks and weeks
Comment
-
Comment
-
Also the sign of an old spongy hose.Originally posted by dirtrace09 View PostHead cracked is probably the culprit. Top swollen hose is a telltale sign of a cracked head.Crew Chief "Tip of the day":
Most handling problems can be solved by adjusting the screw-ball. It can be difficult to fine tune at times. Explaining yourself loudly and striking it on top of the helmet with a dead blow hammer usually works well.
Comment
-
thanks to all. i think i was just worrying for no reason. getting new hoses today. my engine builder said the same thing as you and another guy.Originally posted by Living_TruthThis is your only issue. We've had brand new hoses that swelled up. Some types of stock hoses aren't made to run 22-26 psi, which is what most racing radiator caps maintain, especially if you have a couple seasons on them.
Buy some new, better quality hoses and you'll be fine. Like you said, everything else indicates no problems. You really answered your own question.
Good luck.

Comment
-
-
Rent a radiator pressure from a local parts house. Remove the radiator cap install the tester and pump the cooling system up to 22 to 26 psig. If the hoses expand they have defective rubber in them. While the cooling system is under pressure, look for any loss in pressure by the gauge. Which could could be a sign of additional problems. Diagnose the problems dont just tear into the motor and waste money. There could be a problem not found on a cold motor, but eliminate the easy problems first.
Comment
Comment