Header Temperature

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • bobdoo
    Member
    • Apr 2011
    • 39

    #1

    Header Temperature

    Just checking to see how hot the headers get with my temp gun, I found 2 tubes right at the head were more than 100 degrees cooler than the rest. Can someone fill me in on whats happening and probable repairs. Thanks
  • Duckhnter83
    Senior Member
    • Apr 2013
    • 152

    #2
    I can't tell you numbers but your two inside 4 and 6, 3 and 5 will always run a little hotter temps because the exhaust ports are right next to one another. If the temps are way different between cylinders though you have a ignition or fuel not getting to that cylinder. Most of the time its ignition first check the basics plugs fouled bad wires etc.

    Comment

    • Confused?
      Senior Member
      • Apr 2009
      • 418

      #3
      Also check the gaskets. A bad header gasket will cause much higher temps for a cylinder(s). Could be a valve lash issue.
      Bill W. and Dr. Bob......who could have known.

      Comment

      • bobdoo
        Member
        • Apr 2011
        • 39

        #4
        The two cylinders are #2 and #3. What made me take notice was those cylinders were 100+ degrees cooler, not hotter. Could it be incomplete combustion (leaking passed valve not seating). Also power seems a bit down. Thanks

        Comment

        • Confused?
          Senior Member
          • Apr 2009
          • 418

          #5
          Could be a lash issue, bad plugs, or valves. Have you ran a compression check yet?
          Bill W. and Dr. Bob......who could have known.

          Comment

          • autoshop
            Member
            • May 2007
            • 58

            #6
            Originally posted by bobdoo View Post
            The two cylinders are #2 and #3. What made me take notice was those cylinders were 100+ degrees cooler, not hotter. Could it be incomplete combustion (leaking passed valve not seating). Also power seems a bit down. Thanks
            what type of intake manifold?
            if its a stock those two cylinders feed each other

            Comment

            • perfconn
              Senior Member
              • May 2007
              • 3573

              #7
              Wires are crossed

              Comment

              Working...
              X