High oil temps

[mignum]

Thanks everybody i'm getting a oil cooler now so thanks for the suggestions.Thanks for giving me a heads up on the type of parts to buy as well.

[Egoracing]

Thanks everybody i'm getting a oil cooler now so thanks for the suggestions.Thanks for giving me a heads up on the type of parts to buy as well.

Contact Terry and Performance Connection in TN. He sells the right parts and a good price and wont steer you wrong on them.

[DANNY]

Contact Terry and Performance Connection in TN. He sells the right parts and a good price and wont steer you wrong on them.

Absolutely! And don't forget the 2qt remote filter mounted inline before the cooler cus if anything gets in the cooler its junk cant get it out...

[Hurst390]

AMC motors have oiling issues, what causes them is debatable.

The angle the motor is mounted at isnt a contributing factor....

I dont see mods, late models or any other mid plate mounted motor car mounting the motors at a angle around here.

Ive mounted my race car motors LEVEL and never had issues.

The guy who says he measured 5 degrees on the carb mounting flange was likely reading the 5 degrees the wrong way since the intakes have angle built into them.

I can't disagree with what you say about other cars and how the engine is mounted...I prefer not to mount my level for drainback issues...something I learned from Penske and Allison in their AMC days...chevy is a whole different animal...I just responded to your question on where I personally check the angle....I could go on about pro's and con's of the AMC oiling but wont....My apoligies to the op for the sidetrack....

[Mosidebite]

As for "nobody" mounting their engines at an angle...my Pierce car has mounts in it that has the engine sitting at noticeable angle (running downhill to the back) even with quite a bit of rake in the car.

[stock car driver]

As for "nobody" mounting their engines at an angle...my Pierce car has mounts in it that has the engine sitting at noticeable angle (running downhill to the back) even with quite a bit of rake in the car.

Who said NOBODY?

[mignum]

Contact Terry and Performance Connection in TN. He sells the right parts and a good price and wont steer you wrong on them.

Thanks guys i know terry well he has helped me a ton over about 12 years, since he was under top gun race engines.

[balljoint]

single or multipass?

[sj valley dave]

look it up....Seatrab

[balljoint]

yeah...ready to get one.

50-640-7612 correct?

How much for the package? (fittings etc)

Who has the best deal?

[sj valley dave]

Get hold of Perfconn on this board...very reasonably priced and he will set you up with everything you need..